Fieldserver FS-RA-CLX-PRO Manuel d'utilisateur télécharger pdf (Page 4)

SlotServer Start-Up Guide Page 4 of 12

ProSoft Technology, Inc. is the exclusive provider of FieldServer SlotServers.

For Technical Support call +1 661.716.5100

1.4 SlotServer Ports and Displays

Note that there are several hardware ports available on the SlotServer card, but that this SlotServer model only

makes use of a select few. The ports and displays of interest are as shown in the diagram below:

Figure 1: Diagram of SlotServer showing ports and displays

Scrolling display shows card messages

Card Status Indicators show general card status

Service Pin for LonWorks Commissioning

Communications Status LED’s show status of

communications and card software.

TP/FT10 LonWorks Connection. This two wire

connection is polarity insensitive and can be multi-

dropped into a LonWorks Network.

Ethernet Port. The Ethernet port can be used with

standard Ethernet cables for configuration and

troubleshooting, as well as for Protocols that

require an Ethernet connection

RS-485 Port. This is a standard 2-wire RS-485 port.

Specify as R1 in the configuration.

A label has been provided on the inside of the

cover door for the User to document important or

useful configuration parameters used. In

particular, special provision has been made to

document the Ethernet port IP parameters, as well

as the LonWorks DSN (Domain/Subnet/Node)

allocated by the Network Manager. These fields

are there to be utilized at the User’s discretion.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Fieldserver FS-RA-CLX-PRO Manuel d'utilisateur Page 4